Make sure the frame is the correct height so that the flooring boards will be flush to the top edge of the frame.
Tongue and groove flooring table top.
Steve and hannah are making tongue and groove flooring for a bathroom remodel.
Table top from old tongue and groove maple flooring.
The maple flooring is from a local skating rink that was torn down after a flood.
So there is a bit of sentimental value in this flooring.
My hubby carpenter cut the pieces of flooring to length.
Tools supplies rubber mallet chisel wood glue large metal bar clamps shop rags panel or skill saw compound miter saw optional orbital or belt sander sand paper 80 120 220 wood filler and metal spatula i made mine at techshop san franc.
Feb 1 2014 a table i made from leftover tongue and groove flooring.
To rip off the tongue and groove edges set the table saw to the width of the tongue groove and run the board through the saw.
He cut off all the outside edges removing either tongue or groove to give it a more finished look.
The new top is old tongue and groove pine attic flooring from the early 20 s.
The tongue and groove joint can be easily created using a router with a matched set of router bits or on a table saw using a stacked dado blade set.
The birch was felled on the property and milled on a woodmizer lt15 sawm.
I painted the dresser antique tin and i like its industrial feel.
To begin cut all of the boards you want to use for your tongue and groove assembly to a length of at least one inch longer than the desired finished length using a circular saw or compound.
Attach the boards to the sides of the tabletop using 2 finish nails.
Long story short on the source of the flooring.
My wife and i met there.
Warning don t add glue to the tongue or the groove on hardwood boards.
I made a frame of the same wood and it anchors the piece.
Here are the steps we took to build the hardwood floor table top.