Tools To Make Lock Holes In The Door And Jam

Unless you are installing a prehung door you ll need to trace the outline of the hinges on the jamb and cut an indentation using a router or utility knife.

Tools to make lock holes in the door and jam.

Make sure it s tight and opening in the right direction. Dewalt d180004 door lock installation hole saw kit. If you want your door lockset to operate smoothly and not bind up when you turn the doorknob or try to lock it it s imperative the two holes you drill align perfectly in both directions. The strike is installed on the door frame and contains a hole that catches the latch or bolt that extends from the lock.

This project guide features step by step instructions to tackle after you have already drilled holes in the door. Close the door tightly and let go of the knob. Fortunately cutting out this mortise isn t nearly as difficult as it sounds. You can also refer to the manufacturer s instructions that were included with the door latch or deadbolt you are.

How to fill holes left when a door strike was moved. The strike will hold the bolt in place keeping the door locked until the bolt is retracted using a key or thumb turn. For every doorknob or deadbolt lock installed in your home a hole was drilled in the door jamb and covered with a perforated strike plate. Turn the knob and hold it to keep the bolt retracted.

Screw the hinges onto the correct side of the jamb. Bi metal hole saw d180034. Knowing how to cut a mortise is essential for installing a deadbolt lock. Hang the door in the jamb.

Align the edge of the strike plate s hole just to the door side of the mark and proceed with scoring around the strike plate. Place the door in the jamb and fasten it to the hinges. The centerline of the holes must be at the same height and they must be drilled at the precise 90 degree angle to the face of the material being drilled. Bi metal hole saw d180016.

Use a rotary tool to help you make a perfect mortise for the faceplate of a door latch when installing door hardware. The lock cylinder leaves a hole over 2 inches in diameter completely through the door and there s an additional hole through the door edge where the bolt used to reside. To allow proper clearance for the lock to operate most strike plates are recessed into the door frame.