6 test resistance between pins 2 and 3.
Town and country door locks not working.
Pulling the iod fuse did not work read about cleaning the ground wire connectors at rear edge of both front seats theres a youtube for this.
Their first response to me was this happens all the time.
One problem related to power door locks not working has been reported for the 2010 chrysler town country.
The iod fuse is located in the fuse box which is in the engine.
5 depress switch to unlock position.
3 depress switch to lock position.
The drivers side was a little.
I have a 2005 town and country.
Power door lock on pass sliding door not working i just had mine fixed at the dealer for the same problem.
Please also check out the statistics and reliability analysis of the 2010 chrysler town country based on all problems reported for the 2010 town country.
2 disconnect wire connector from back of door lock switch.
Http amzn to 2pukk1s actuator lock for chrysler town country one i bought.
4 using an ohmmeter test switch resistance between pins 2 and 3.
Locks quit working with remote or button on the door.
And also check door lock switch door lock switch 1 remove door trim panel.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Tried disconnecting the battery and that worked a few times then quit altogether.
How can the automatic locks on 2005 chrysler town country be fixed simply remove the iod fuse for about ten seconds and replace it.
The most recently reported issues are listed below.